Detergent Injector with Hose

Pressure washer detergent injector/strainer with 48 inch (1.22 m) hose and 3/8 inch (9.53 mm) Male National Pipe Thread (MNPT) x 3/8 inch (9.53 mm) Female National Pipe Thread (FNPT) brass garden hose connector with adjustable flow chemical injector. The chemical injector/strainer has a built-in stainless steel check valve. Attach the injector/strainer to the 48 inch (1.22 m) hose and connect the hose to the brass garden hose connector. Then connect the garden hoses to the brass connector. Once hooked up, place the injector/strainer in the detergent container. The injector/strainer has an internal brass weight that keeps the strainer at the bottom of the container. Turn on the water. The detergent enters through the strainer preventing debris from entering the pump. The built-in stainless steel and Viton® style check valve prevent water from flowing back into the soap solution. The detergent inflow can then be adjusted using the adjustable flow knob on the top of the brass connector. COLD WATER ONLY. Forney 75172 is a replacement Detergent Injector Strainer.

SPECIFICATIONS

• Fitting: Detergent injector/strainer with hose
• Material: Brass and plastic housing with stainless steel check valve
• Garden Hose Inlet: 3/4 inch (19.05 mm) Female National Pipe Thread (FNPT)
• Garden Hose Outlet: 3/4 inch (19.05 mm) Male National Pipe Thread (MNPT)
• Hose Length: 48 inch (1.22 m)
• Gallons Per Minute (GPM) Range: 1.5 - 4.0 GPM
• Maximum Temperature: 160° F (71.1° C)
• Maximum PSI: 140 PSI

30 Days:

• 30 Days: Product: Free of defects in material and workmanship that may occur under normal use and care.